Sign in to follow this  
mojoicus

Hyper 48 problems

Recommended Posts

phile    0
will any insulated wire do or does it have to be a certain size?

Thz

The objective is simply to create an electrical bridge between the two leads, so it need only be small enough to fit in the tiny hole, beside the existing wire. You can achieve this with a paper clip, as mentioned by a previous poster. So, any wire will do, as long as you can stuff it in that small opening.

Share this post


Link to post
Share on other sites
bigyinn    0
completely lost sry :)

just not sure what to do

Ok, I just did this, this evening, and it works like a charm.

Here's what you do:

1- Find a small length of insulated wire and strip off a quarter-inch of the insulation from each end

2- On the Hyper48's 4-pin mobo connector, insert one end of your wire segment into the hole alongside the BLUE wire, and the other end of the wire segment alongside the YELLOW wire. (Just stuff the exposed portion of each end of your wire segment right into small holes.)

3- Secure the wire segment to the rest of the wires with a twist-tie

4- Re-connect the 4-pin connector to the mobo and boot

The fan should now be operating at full speed - roughly 3000 rpm.

-phil

P.S. This HSF absolutely destroys the Zalman CU7000 that it replaced. Shaved 6 degrees C off my idle.

Phile, thanks for this post, just what im looking for!! Nice one!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this