TomP

Installation on Intel LGA1151 - Bracket orientation

Recommended Posts

TomP    0

Hi all,

 

Just mid-build and I'm stuck and need a little help please. I have the Seidon 240V and I'm installing on an LGA1151. I am unsure of the orientation for the bracket as if I follow the installation guide it would be sitting as shown in the attached photo (orientation 1) and I was concerned about it contacting the screws on the back of the CPU socket, however if I rotate it 90 degrees (orientation shown for AMD but correct way up for Intel) then it seems to be a better fit as per the other photo.

 

Can someone please advise which way round it should be?

 

Thanks

 

Tom

orientation1.jpg

orientation2.jpg

Share this post


Link to post
Share on other sites
Mohd Dzuld    3

Reference only , below is installation for Intel .

Nepton 280 Bracket

mybackplate.jpg.342823c4cb7cfcf88e019b27788b8d91.jpg

MasterLiquid 240 Bracket

CM_MasterLiquid_Pro_240-38.thumb.jpg.996b9bfbd1a2a83f7e3ac954a5caaec1.jpg

Share this post


Link to post
Share on other sites
TomP    0

Thanks Mohd, the second picture looks right to me, that was the orientation I believed it should be however the image in the instructions shows otherwise.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now