• Announcements

    • CM Nick

      AM4 Socket Support   04/24/2017

      Due to technical issues, the topic on "AM4 Socket Support" has disappeared. We apologize for any inconvenience this has caused and we are trying our best to have this topic back up as soon as possible.   As we read in the topic, there is a lot of discussion going on when the new brackets will be arriving. We can tell you now that the brackets will be ready for pre-order on our CM Store EU tomorrow and will be ready for shipment around the 16th of May.   You can continue the discussion in this newly created topic:     

Recommended Posts

Igor Below    151
On 19.03.2017 at 4:39 AM, Белов Игорь said:

DSC_0297.JPG

-1384553295-914063254.jpg

 

 

 

 

 

 

 

 

 

 

 

DSC_0314.JPG

Hello everyone, good time of day! So the time has come when I remove the stelloplastic matrix from my project model.

Edited by Igor Below
  • Upvote 2

Share this post


Link to post
Share on other sites
Igor Below    151
Just now, Белов Игорь said:

The process is fascinating, but long, as it is necessary to manufacture the matrix parts in order to make it fold-down.

 

Share this post


Link to post
Share on other sites
Igor Below    151

Unfortunately all the photos in the process of creating the matrix did not come off because the work is very dirty, all hands were in the resin even though I used gloves.I'll postorazh to tell in words. The model was covered with wax, followed by a separating layer, and the gluing of fiberglass impregnated with resin.

Share this post


Link to post
Share on other sites
Igor Below    151
Just now, Белов Игорь said:

The next stage will be the preparation of the matrix for the creation of the project model.

Edited by Белов Игорь

Share this post


Link to post
Share on other sites
samca    11

Awesome so far mate, seeing resin jobs motivates me on my resin work too.
I know resin is a :) of a job and it's messy. Following your work :D

Share this post


Link to post
Share on other sites
Igor Below    151

Hello friends decided to put a little pictures of the work done over the past week. Matrixes made of fiberglass, with epoxy resin, were made. There are a lot of work done, but in front there is not less.

DSC_1208.JPG

 

 

 

 

 

 

 

 

 

 

_20170423_133329.JPG

_20170423_133400.JPG

Edited by Igor Below
  • Upvote 3

Share this post


Link to post
Share on other sites
Igor Below    151

Hello friends! I will present several photos so you can see the whole process of the work done, removing the matrix.

 

 

DSC_1254.JPG

 

 

 

Edited by Igor Below
  • Upvote 3

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now