Sign in to follow this  
Veracis

CM 690 III and Neptune 280L

Recommended Posts

Veracis    0

Can the Neptunes Radiator fit the Top recess of the 690 III? Will it fit with both a push and pull fan?

 

Rad : 311 x 139 x 30 mm

Fan : 140 x 140 x 25 mm

 

80mm clearance needed from case to ram

 

By measurment I have 88mm.  Is that 8 mm enough? Would it be too close to fit say a H105 thick rad (38mm?)

I am not sure the 311mm length will fit.  

 

Anyone have experience with this?

Share this post


Link to post
Share on other sites
ScienceBoy    2

i think 280mm rad can't fit at the top of CM 690 III

 

if you have measure 88mm, maybe it can do push pull :)

it will very close with the edge of the motherboard

Share this post


Link to post
Share on other sites
CM Jerry    43

Yes, it's difficult a little bit to fit on the top if you install 280mm radiator.

We will try to make a proper size with popular cases :)

Share this post


Link to post
Share on other sites
Veracis    0

Thanks for there responses. I have 2 140s on top at the moment. I was hoping to try and get a 280mm in there but for now I guess I can stick with the Seidon 120V.  my 4770k core temps are below 80 during benching at a mild overclock (4.2) I haven't tried to push it much further yet.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this