Search the Community

Showing results for tags 'thermal paste'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Case Mod World Series 2017
    • Case Mod World Series 2017
  • Announcements and Giveaways
    • Announcements
    • Giveaways
    • CES & Computex
  • PC Building Guide
    • Reviews and Unboxing
    • Build Advice
    • Build Worklogs
  • Hardware
    • Cooling
    • Cases
    • Power Supplies
    • Peripherals
  • General Discussion
    • General Hardware
    • Overclocking
    • Game Zone
    • Product Suggestions
  • Modding
    • Mod Lounge
    • Mod Worklogs
    • Mod Contests

Calendars

  • Community Calendar

Found 2 results

  1. Goodnight. I would like a link where I can read more about this product: Http://articulo.mercadolibre.com.ve/MLV-486966931-pasta-termica-anipacitor-cooler-master-30-g-_JM Thank you
  2. Someone did this build and put a hyper T2 on an AMD 4130. When i was given the unit, I found that the cooling unit was twisted. i thought that perhaps it best to remove it, clean it and the processor and put it back with IC Diamond which someone recommended. When I removed the cooling unit I was surprised that there was a gray paste (I assume it is cooler master) on the MB processor socket. I was able to get it off of the cooler although it is hard to get it out between the copper tubes. What concerns me is that the past is in about 8 of the MB socket holes towards the edge. I did my best to clean up using q-tips and coffee filters with 91 percent Isopropyl Alcohol and denatured ethanol. But, there is no way to get the paste out of the holes. Luckily, I was able to get the paste out of the processor pins although I think there is some paste under between the heat sink and processor. I don't think it wise to soak it in the ethanol. I am afraid the board is toast. I saw all sorts of posts...sewing needles, alcohol, high pressure air. I am afraid to try those. Any thoughts or experience would be appreciated.