Search the Community
Showing results for tags 'mb530p'.
Found 6 results
-
Bonjour, J'ai acheté le boîtier masterbox mb530p. Mais je ne sais pas où brancher le câble ARGB du boîtier sur ma carte mère, le câble du boîtier à 3 broches et sur ma carte mère Aorus b450 pro (qui est compatible avec rgb fusion) à 5 broches. Si quelqu'un peut m'aider! Merci -
Hi, I'm setting up a PC using a MasterBox MB530P case, and I've done it so far by not connecting my ARGB fans to the motherboard and instead just using the included ARGB controller and plugging the SATA and molex power cables into my PSU. This gets my fans to spin in a consistent rainbow pattern at least. My motherboard is a Gigabyte X570 UD AMD which does have a 4 pin LED_C1 (RGB LED Strip Header) which the manual says can be used to connect a standard 5050 RGB LED Strip (12V/G/R/B) with maximum power rating of 2A (12V). The cable coming out of the 2 to 3 ARGB splitter included for the 3 fans though is a 3 pin. Would I be able to connect the 3 pin ARGB cable to the RGB LED Strip Header? I assume not because there would be no signal passed for fan speed, but I was just wondering in case they could be controlled. Thank you! Best, James
-
Just recently purchased the MB530P, got everything hooked up and the front power led doesnt work. Front fans light up fine the led to the right works but not the power button. Any suggestions?
-
Hi guys! I'm thinking to buy MasterBox MB530P and I hope someone can tell me if it will be better to install a 360 AIO in front of the case (moving the 3 x pre installed fan to the top/back) or a 240 AIO at the top. Thank you!
-
I'm looking to get a MB530P and concern about the length of the PWM cable fans for the fans at the front and if (in my mind) the bottom fan can't reach the header (SYS_FAN2) on the motherboard (MSI B450 Pro Gaming Carbon). Will it be able to reach said header or should I invest in a splitter/hub for it?
-
mb530p Max ARGB Devices Using Built-in Controller MB530P
bossrigel posted a topic in Masterbox 5 Series
Hi, How many fans/led trips/etc can be used by the built-in argb controller of the MB530P case? Cant find any reliable sources.
