Search the Community

Showing results for tags '120xl'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Announcements and Giveaways
    • Announcements
    • Giveaways
    • CES & Computex
  • PC Building Guide
    • Reviews and Unboxing
    • Build Advice
    • Build Worklogs
  • Hardware
    • Cooling
    • Cases
    • Power Supplies
    • Peripherals
  • General Discussion
    • General Hardware
    • Overclocking
    • Game Zone
    • Product Suggestions
  • Modding
    • Mod Lounge
    • Mod Worklogs
    • Mod Contests

Calendars

  • Community Calendar

Found 7 results

  1. Hey everyone. When I got my computer, the cooler was preinstalled, so I don't have the 1151 backplate/brackets and I'm moving from AM3 to 1151 (8th). Is there any way to buy this from the US store? (or anywhere else but EU) https://www.cmstore.eu/parts-replacements/cooling/accessories/seidon-120xl-240m-accessories-pack/
  2. Nepton 120XL

    From the album Nepton 120XL

  3. Nepton 120XL

    From the album Nepton 120XL

  4. Nepton 120XL

    From the album Nepton 120XL

  5. Nepton 120XL

    From the album Nepton 120XL

  6. So I purchased two of these units, one for a new AMD system and the other for a first generation i7 930 CPU. On the AMD motherboard there are multiple 4 pin connectors. I plugged the pump into the CPU one, and the fan into the case one. I'm not sure if this is correct, but the instructions were vague on which one should go where. I know there is the Y split cable as well. But I cannot hook up both fans and the pump using that single Y connector. This one seems to be working fine, but it would be nice to have confirmation which plugs to go into. Unit is quiet enough. The i7 930 on the other hand only has 1 4 pin connect and a few 3 pin chassis fan connectors. So for that I hooked both the fan and the pump to the Y connector and plugged it into the CPU fan pins. It's staying cool but the fan is running at 100% all of the time, which is loader than the ball I had in place before. What's the proper way to get this setup on the older first generation i7 based motherboards. I was actually looking to see if I could find a better MB but this chip is too old and there doesn't seem to be much on the market. Any advice would be appreciated.
  7. Enforcer cooling

    Hello, lately I received (finally) my enforcer case (without the side fan). I've noticed that it comes with the Megaflow front fan and another pretty simple rear fan. I wanna know if having 1 Megaflow front fan and 1 Megaflow top and 1 Jetflo rear fan is enough for overclocking or should I maybe use x2 Jetflo in front, x2 Jetflo in top and x1 Jetflo in rear? Also, I wanna get the Seidon 120XL and I would like to know if I can fit Seidon 240M in my case on top or not? And if I will get 120XL, can I change the fans to whatever fan I would like to put there in the size of 120mm (something like SickleFlow)? Thank you!