In my project I'm going to mod one Cooler Master Elite 341 Midi Tower.
Final state: Gallery with bigger images
Vote on me if you like it
MORE IMAGES BELOW
Phenom II X2 @ X4 B55 @ 3800MHZ - 1,3500V
Gigabyte GA-MA785GM US2H
2 x 2GB Kingmax DDR2 800MHZ
MSI GTX 560 TI TwinFrozr @ 950MHZ - 1,000V
Seagate 7200.12 1TB
Scythe Ninja 2
In my project I will make (or finish) the following modifications:
1; Case mod
- Window mod
- Front panel mod
- Full body paint
- 3D Carbon vinyl cover
- Sound and vibration absorbing
- Light mod
- Cable management
- Move HDD to the second 5,25" slot
- Remove the unnecessary HDD holders.
2; CPU cooler mod:
- Black painting
- Carbon top cower
3; DVD drive paint
I don't have many images of the original state of the parts, but I will try to show how many modifications I made.
I tried to make useful, good looking, and top quality modifications. I hope you will see it
First I introduce the parts, and then I will show one by one what modifications I made.
The Original state:
Mixed pictures of the moding phases:
I made one little circuit to switch the leds. When the motherboard gives the signal, then this circulation is switch on between the leds and +5V.
This is needed because the motherboard can't supply enough power for the leds. I could not connect the leds directly to the PSU, because then the red HDD leds would not blink (the are behind the on-off switch). And if there some hardware problem, then the motherboard gives a blinking signal to the green Power leds.
It contains two PNP transistors (one HDD and one Power), and for resistor (two for the HDD and two for the Power).