Ráti Levente

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Ráti Levente

  • Rank
    LED Head
  • Birthday 08/02/1985

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi everyone! I'm from Hungary and this is my first creation. The main properties of my case are the irregular shape and the simple but effective cooling system. I wanted to make an easy to use and low noise pc, with the neccessary fans (at low speed). So i had to choose a good and simple shape, which is a pvc tube. Shortly I will put everything inside and put two big fan both end of the tube. Hardware: psu - 400 W (under construction) with Cooler Master 12 cm fan mainboard - P31 C2D E7200 2.53 2 Gb DDR2 800 Mhz RAM GeForce 9600 GT 512 Mb with Scythe Musashi cooler 250 Gb HDD two Cooler Master 200 mm fan i will upload some pics next time from the first steps. Hi everybody! This week was very long for me. I left the job for a week and i could spend some time for my project. I had to do almost everything during this time. Because of the low budget some parts are made from junk. At first I obtained the tube what is a rest of a channeling. Then I cut four plastic rings what I use to make stable the internal unit. These rings were put on three iron rods. These rods keep the components. I cut out from a donor case some parts as the tray, power button, HDD holder. I make two hole both side of the PSU with grids and cable sleeving for the better cooling. The lower system fan needs an aperture, so I cut it out too, then put grids there. The upper fan’s aperture with grid is on one of the rings, that will be the cover of the case. After a lot of assembling and disassemling I could set the positions of the components. When everything was fit I started to paint it. Unfortunately I’m not a professional.