I am interested in Cooler Master Stacker, but a review mentions some problem, and I want to knew if these problems will be improved or is there a point with them?
On the top of the case, two visual (symmetrical) dents can be found. It is caused by the tight fit of the top aluminum panel meeting with the vertical steel structures within the case. This may only be present with our review sample and may not be a problem with retail versions. However, we do urge users to make a quick check before purchasing one.
The drive bay faceplates are terribly inconvenient to take off or insert back into the casing. Frankly, we were surprised Cooler Master did not make any provision to easily detach the entire front faÃƒÂ§ade, which would have made drive installations or changes a whole lot easier. This is one of the bigger drawbacks to the CM Stacker design.
Extracting the dust filter on each of the drive bay faceplates is quite tough and doing this repetitively could even damage the mesh of the faceplate. Cooler Master could have spent a little more time to design an easier solution to extract the dust filter. Our suggestion for now is to wash the entire faceplate and dry it thoroughly, which saves time and effort
The PSU faceplate that double up as additional locations for 80mm case fan installations is not equipped with enough mounting holes to prevent vibration when higher speed case fans are affixed to it.
Installing drives or accessories with rails wasn't exactly a smooth experience. The clearance on the casing is a tad tight and requires you to nudge and squeeze the drive in. Once the drive's tail fits in and catches the rail lines on the casing, sliding the drive to its flushed position is a cinch. The good thing about the tight fit is that the case aids to cut down on drive vibrations.
Note that the casing did not ship with an instruction manual. You will have to download the PDF version from the product page on their website.
All opinions is taken from these review: http://www.hardwarezone.com/articles/view.php?cid=22&id=1121