David

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About David

  • Rank
    LED Head

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I've just completed my first PC build using the MC 500mt as the case. There's a control box on the back for the fans and the rgb lighting included with the case. I cannot figure out the wiring for this as none of the fans or the rgb panel inside the case are working. When I figured out that software was also required I installed it only to receive a message to "Plug in your CM device to get started. The instructions that came with the case are useless or I'm just too new at this. I assumed the "controller" would be set to go but I'm guessing that additional wiring is required. Fans are plugged in, rgb light panel is plugged in, there's one pin plug in the bottom left side and one connector on the bottom right without anything plugged into it. Is that suppose to be connected somewhere somehow? Thanks for any help. Guessing it's something simple. Better documentation Cooler Master please!