I am an owner of the Elite 130 and I was wondering if there was a refresh (140?) being planned. If so, here is a small list of things I would like to see in an updated version. a. A third PCI slot or room to allot for 2.5 slot GPUs, (or GPU & Kraken G10), fans to force air the to GPU like on the CPU side of the Elite 130, similar the Ncase M1 & Lian Li. Not my question, but: http://www.tomshardware.com/answers/id-3153159/slot-gpu-fit-mini-itx-cube-cases.html My case with a 120x25mm side fan on the CPU side (no zip ties or bracket needed): http://i.imgur.com/KNktDAb.jpg There is no room for a 120x15mm fan on the GPU side: http://i.imgur.com/Nf4AFKe.jpg NCase http://i.imgur.com/xZawVg3.jpg http://i.imgur.com/yPuuNzV.jpg Lian Li PC-Q10 http://www.modders-inc.com/wp-content/uploads/image//2016/01/Side-View-Hardware-inside.jpg Lian Li PC-Q01 http://www.lian-li.com/tw/files/2014/01/q01-f-03.png b. Allowance for the drive bay to be removed by screws instead of rivets.... c. More vents on the case - Vents for aftermarket GPUs to exhaust air: Problem is like the EVGA 1070 pictured here, the heat goes up and down back into the case: http://cdn.techfrag.com/wp-content/uploads/2016/05/EVGA-GTX-1070-SC-Gaming_Computex-2016_2.jpg Even the AMD card CM has pictured would blow back in to the case: http://images.bit-tech.net/content_images/2013/04/amd-radeon-hd-7990-6gb-review/7990-7b.jpg LZ7 Case has a solution by making vents along the top area of the case to allow heat from the GPU to be exhausted. http://i0.wp.com/www.lazer3d.com/wp-content/uploads/2016/08/LZ7-Window-GPU-Side-Panel.jpg?fit=640%2C411 And bottom: http://i1.wp.com/www.lazer3d.com/wp-content/uploads/2016/08/LZ7-Base-Panel-HiFi-Feet.jpg?fit=640%2C480 http://i.imgur.com/doT9JrH.jpg - More exhaust vents to allow for 2 - 120mm fans to be installed: My system with 2 - 120mm x 25mm fan as an example. One is on top of the SFX PSU: http://i.imgur.com/r4SGbKu.jpg?1 Core 500 example http://techreport.com/r.x/fractaldesigncore500/front34.jpg http://techreport.com/r.x/fractaldesigncore500/open-top.jpg Also perhaps making the Elite taller to allow those with a SFX PSU and with removal of the drive bay, to install a 240 radiator d. (Minor request) Make all the vents consistent. The sides have a grid, the top is an offset grid, the front is honeycomb... e. (Minor request) Make the cover 3 separates panels instead of 1.